Toro 30809 Groundsmaster 3500-G, Руководство оператора

Страница: 45 / 52

Maintaining the Cutting
Unit
Separating the Cutting Unit
from the Traction Unit
1. Position the traction unit on a level surface, lower the
cutting units to the ground, shut the engine off, and
engage the parking brake.
2. Disconnect and remove the hydraulic motor from the
cutting unit (
Figure 61 ). Cover the top of the spindle
to prevent contamination.
Figure 61
1. Motor-mounting bolts
3. Remove the lynch pin securing the cutting unit carrier
frame to the lift-arm pivot pin (
Figure 62 ).
Figure 62
1. Lynch pin 2. Lift-arm pivot pin
4. Roll the cutting unit away from the traction unit.
Mounting the Cutting Units to
the Traction Unit
1. Position the traction unit on a level surface and shut
off the engine.
2. Move the cutting unit into position in front of the
traction unit.
3. Slide the cutting unit carrier frame onto the lift-arm
pivot pin. Secure with the lynch pin (
Figure 62 ).
4. Install the hydraulic motor to the cutting unit ( Figure
61 ). Make sure that the O-ring is in position and not
damaged.
5. Grease the spindle.
Servicing the Blade Plane
The cutting unit comes from the factory preset to a 5 cm
(2.00 inch) height of cut and a blade rake of 7.9 mm ( 0.310
inch). The left and right heights are also preset to /-
0.7 mm (0.030 inch).
The cutting unit is designed to withstand blade impacts
without deformation of the chamber. If a solid object is
struck, inspect the blade for damage and the blade plane for
accuracy.
Inspecting the Blade Plane
1. Remove the hydraulic motor from the cutting unit and
remove the cutting unit from the traction unit.
2. Use a hoist (or minimum of 2 people) and place the
cutting unit on a flat table.
3. Mark one end of the blade with a paint pen or marker.
Use this end of the blade to check all heights.
4. Position the cutting edge of the marked end of the
blade at 12 o’clock (straight ahead in the direction of
mowing) and measure height from table to cutting edge
of blade (
Figure 63 ).
G011353
6:00
12:00
9:00 3:00
Figure 63
5. Rotate the marked end of the blade to the 3 and 9
o’clock positions and measure the heights (
Figure 63 ).
45