Toro 30809 Groundsmaster 3500-G, Руководство оператора

Страница: 33 / 52

Using the Cutting-Unit Service
Latch
When servicing the cutting units, use the service latch to
prevent injury.
1. Center the cutting unit sidewinder with the traction
unit.
2. Raise the cutting units to the transport position.
3. Set the parking brake and turn off the machine.
4. Release the latch rod ( Figure 32 ) from the front carrier
frame retainer.
Figure 32
1. Latch hook
5. Lift the outside of the front cutting units and place the
latch over the frame pin mounted on the front of the
operator's platform (
Figure 32 ).
6. Sit on the operator seat and start the machine.
7. Lower the cutting units to the mow position.
8. Turn off the machine and remove the key from the
ignition.
9. Reverse this procedure to unlatch the cutting units.
Lubrication
Greasing the Bearings And
Bushings
Service Interval: Every 50 hours (Lubricate all bearings and
bushings daily when conditions are dusty
and dirty.)
Every 500 hours/Yearly (whichever comes first)
Lubricate grease fittings regularly with Number 2
general-purpose, lithium-based grease. Lubricate the bearings
and bushings daily when operating conditions are extremely
dusty or dirty. Dusty or dirty operating conditions could
cause debris to get into the bearings and bushings, resulting in
accelerated wear. Lubricate grease fittings immediately after
every washing, regardless of interval specified.
The grease fitting locations and quantities are as follows:
•
Rear cutting unit pivot ( Figure 33 )
Figure 33
•
Front cutting unit pivot ( Figure 34 )
Figure 34
33