Toro 30809 Groundsmaster 3500-G, Руководство оператора

Страница: 18 / 52

Hour Meter
The hour meter ( Figure 18 ) indicates the total hours of
machine operation. The hour meter starts to function
whenever the key switch is in the On position.
Cutting-Unit Lever
To lower the cutting units to the ground, move the
cutting-unit lever (
Figure 18 ) forward. The cutting units will
not drop unless the engine is running. To raise the cutting
units, pull the lever rearward to the Raise position.
Note:
The lever does not have to be held in the forward
position while the cutting units are lowered.
Move the lever to the right or left, to move the cutting units
to the right or left. This should only be done when the
cutting units are raised or if they are on the ground and the
machine is moving.
DANGER
Shift the cutting units to the uphill side of the
machine when on the side of a hill.
Using the cutting units on the downhill side of the
machine can decrease stability. This could cause
a rollover, which may result in personal injury or
death.
Coolant-Temperature Light
The coolant-temperature light ( Figure 18 ) will turn on if the
coolant temperature raises above a set level. The engine will
stop if the coolant temperature raises another 10° F.
Oil-Pressure Light
The oil-pressure light ( Figure 18 ) will turn on if the oil
pressure drops below a set level.
Alternator Light
Check or repair the charging system if the alternator light
turns on when the engine is running (
Figure 18 ).
Check-Engine Light
Check or repair the engine if the check-engine light turns on
when the engine is running (
Figure 18 ). Refer to the Service
Manual for possible causes.
Parking Brake
Engage the parking brake whenever the engine is shut off
(
Figure 18 ). Pull up on the lever to engage the parking brake.
Note:
The engine will stop if you press the traction pedal
with the parking brake engaged.
Lift-Lever Lock
Move the lift-lever lock ( Figure 18 ) rearward to prevent the
cutting units from dropping.
Fuel Gauge
The fuel gauge ( Figure 19 ) indicates the amount of fuel in
the fuel tank.
g021400
2
1
Figure 19
1. Seat-lock lever 2. Fuel gauge
Adjusting the Seat Forward or
Backward
Move the lever ( Figure 19 ) on the side of the seat outward
and slide the seat to the desired position. Release the lever
to lock the seat into position.
18