Toro 30411, Руководство по обслуживанию

Страница: 39 / 262

Groundsmaster 4100−D Page 3 − 17 Kubota Diesel Engine (Rev. A)
Engine Installation
1. If removed, install engine mount brackets to the en-
gine using Figure 10 as a guide.
2. Connect hoist or lift to the front and rear lift tabs on
engine.
3. Position fan shroud around the engine fan.
CAUTION
One person should operate lift or hoist while the
other person guides the engine into the machine.
IMPORTANT: Make sure not to damage the engine,
fuel and hydraulic lines, electrical harness, or other
parts while installing the engine.
4. Slowly lower engine into the machine.
5. Align engine to the rubber engine mounts and secure
with cap screws, rebound washers, and flange head
locking nuts.
6. Secure fan shroud to the radiator with four cap
screws, flat washers, and locknuts. Make sure that
clearance between shroud and fan is at least .180” (4.6
mm) at all points.
7. Install coolant reservoir bracket and reservoir to fan
shroud.
8. Connect throttle cable to the speed control lever with
washer and lock nut. Install cable to mounting bracket
(Fig. 12). Adjust throttle cable (see Operator’s Manual).
9. Connect fuel line to the injection pump fitting (Fig.
12).
IMPORTANT: Support hydraulic pump assembly to
prevent it from falling and being damaged.
10.Install hydraulic pump assembly to engine (see
Pump Assembly in Chapter 4 − Hydraulic Systems).
11. Connect two wires to neutral switch on traction
pump.
12.Connect wires and/or electrical connections to the
following electrical components:
A. The temperature sender and alternator (Fig 11).
B. The engine run solenoid and fuel pump (Fig. 13).
C. The high temperature shutdown switch and glow
plug (Fig. 14).
D. Battery, frame, and wire harness ground to the
engine block (Fig. 15).
E. The starter (Fig. 15) and low oil pressure switch
(near starter).
13.Install air cleaner assembly to the engine (see Air
Cleaner Installation).
14.Install exhaust system to machine (see Muffler
Installation).
15.Connect coolant hoses to the radiator. Make sure ra-
diator drain is shut. Fill radiator and reservoir with cool-
ant (see Operator’s Manual).
16.Check position of wires, fuel lines, hydraulic hoses,
and cables for proper clearance with rotating, high tem-
perature, and moving components.
17.Position battery to machine. Connect positive bat-
tery cable first and then negative battery cable. Secure
battery to machine with strap and cover.
18.Check and adjust engine oil as needed (see Opera-
tor’s Manual).
19.Check and adjust hydraulic oil as needed (see Oper-
ator’s Manual).
20.Bleed fuel system (see Operator’s Manual).
21.Operate hydraulic controls to properly fill hydraulic
system (see Charge Hydraulic System in Chapter 4 −
Hydraulic Systems).
Kubota
Diesel Engine