Toro 30411, Руководство по обслуживанию

Страница: 116 / 262

Groundsmaster 4100--D Hydraulic System Page 4 -- 74
Hydraulic Control Manifold: Cutting Deck Lift/Lower
1. Lift/lower hydraulic manifold
2. Valve plate
3. Flat washer (2 used)
4. Cap screw (2 used)
5. Grommet (4 used)
6. Flat washer (2 used)
7. Lock nut
8. Hydraulic fitting (2 used)
9. O--ring
10. O--ring
11. 90
o
hydraulic fitting (4 used)
12. Cap screw (2 used)
13. 90
o
hydraulic fitting
14. O--ring
15. Test nipple
16. Fitting cap
Figure 58
2
11 8
4
3
1
13
14
10
10
10
9
9
16
15
12
7 6 5
5
FRONT
RIGHT
Removal
NOTE: The ports on the manifold are marked for easy
identification of components. Example: C1 is the con-
nection port from the LH wing deck lift cylinder and CHG
is the charge circuit connection (See Hydraulic Sche-
matic to identify the function of the hydraulic lines and
cartridge valves at each port).
1. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
2. To prevent contamination of hydraulic system during
manifold removal, thoroughly clean exterior of manifold
and fittings.
3. Disconnect hydraulic lines from manifold and put
caps or plugs on open hydraulic lines and fittings. Label
disconnected hydraulic lines for proper reassembly.
4. Remove hydraulic manifold from the frame using
Figure 58 as guide.
Installation
1. Install hydraulic manifold to the frame using Figure
58 as guide.
2. Remove caps and plugs from fittings and hoses.
Properly connect hydraulic lines to manifold.