Toro 30326, Руководство оператора

Страница: 18 / 48

18
Step
6
Installing the Hairpin Cotter
Pins and Spacers
Parts needed for this step:
Qty. Part
2
Hairpin cotter pin
6
Spacers
Procedure
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
Note: Make sure there is at least one spacer used on each
height–of–cut post.
1. Remove the existing rear hairpin cotter pins from the
rear height–of–cut posts.
2. Install a spacer onto both rear height–of–cut posts and
install the hairpin cotter pins.
3
2
1
m–7584
Figure 12
1. Hairpin cotter
2. Spacer
3. Height–of–cut post (rear
shown)
3. On the opposite side of the muffler, install unused
spacers onto front and rear height–of–cut pins and insert
the hairpin cotter pins (Fig. 13).
m-6505
3
2
1
Figure 13
1. Hairpin cotter
2. Unused spacers
3. Height–of–cut post (front
shown)
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
Think Safety First
Carefully read all the safety instructions and decals in the
safety section. Knowing this information could help you or
any bystanders avoid injury.
The use of protective equipment for eyes, hearing, feet and
head is recommended.
This machine produces sound levels in excess of
85dBA at the operator’s ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.
Caution
1
2
Figure 14
1. Caution 2. Wear hearing protection
Controls
Become familiar with all the controls (Fig. 15) before you
start the engine and operate the machine.