Toro 30326, Руководство оператора

Страница: 17 / 48

17
Step
5
Installing the Control Rods
Parts needed for this step:
Qty. Part
2
Control rods
2
Cotter pin
2
Clevis Pin
2 Washer
2 Hairpin cotter pin
Procedure
1. Install the control rods into the upper control bar and
the blade control bail. Secure the control rods with 2
cotter pins (Fig. 9).
m–7586
1
2 3
1
4
Figure 9
1. Control rod
2. Upper control bar
3. Blade control bail
4. Cotter pin
2. Make sure the rod fittings are equal distance onto each
control rod. The rod fittings should be approximately
3–1/2 inch (89 mm) from the start of the threads for the
handles lowest position (Fig. 10).
3. Slide clevis pins through rod fittings and mounting
holes in idler brackets (from outside) (Fig. 10). Secure
with washers and hairpin cotters (Fig. 10).
Note: Make sure brake rod is installed in front (F)
mounting hole in idler bracket.
1
3
2
6
4
7
8
m–7593
5
Figure 10
1. Control rod and fitting
2. 3–1/2inch (89 mm)
3. Idler bracket
4. Clevis pin
5. Washer
6. Hairpin cotter pin
7. Rod fitting
8. Hole F
4. Check the gap between upper control bar and fixed bar
with wheel drive fully engaged. Gap should be
approximately 1 to 1-1/4 inch (25–32 mm) (Fig. 11).
Note: The upper control bar and fixed bar must be parallel
when in engaged, drive, relaxed and brake positions.
5. Check the operation. If adjustment is required, remove
hairpin cotter, washer and clevis pin securing control
rod fitting to idler bracket.
6. Thread fitting up or down on rod until proper position is
attained and install the fitting into the idler bracket with
clevis pin, washer and hairpin cotter.
1
5
3
4
2
m–6443
Figure 11
1. Control rod
2. Fixed control bar
3. Parking brake lever
4. Upper control bar
5. 1 to 1–1/4 inch
(25–32mm) gap
6. Fitting
7. Check the parking brake adjustment. Refer to Checking
the Brakes, page 32.