Toro 22317, Руководство оператора

Страница: 27 / 44

Viscosity: See table below
F
5
-20 0 20 40 60 80 100
C
5
-30 -20 -10 0 10 20 30 40
USE THESE SAE VISCOSITY OILS
32
10W-30
5W-20, 5W-30
G000650
Figure 20
Changing the Oil and Filter
1. Start the engine and let it run for five minutes.
This warms the oil so it drains better.
2. Park the traction unit so that the drain side is
slightly lower than the opposite side to ensure
that the oil drains completely.
3. Lower the loader arms, chock the wheels, stop
the engine, and remove the key.
Components will be hot if the traction
unit has been running. If you touch hot
components you may be burned.
Allow the traction unit to cool before
performing maintenance or touching
components under the hood.
4. Place one end of a hose on the drain valve and
the other end in a pan (Figure 21).
Figure 21
1. Oil drain valve
5. Open the drain valve by turning it
counterclockwise, pulling out as you turn it
(Figure 21).
6. When the oil has drained completely, close the
drain valve and remove the hose.
Note:
Dispose of the used oil at a certified
recycling center.
7. Remove the old filter and wipe the filter
adapter (Figure 22) gasket surface.
1
2
3
G000653
Figure 22
1. Oil lter 3. Adapter
2. Gasket
8. Pour new oil of the proper type in through the
center hole of the filter. Stop pouring when
the oil reaches the bottom of the threads.
9. Allow a minute or two for the oil to be
absorbed by filter material, then pour off the
excess oil.
10. Apply a thin coat of new oil to the rubber
gasket on the replacement filter (Figure 22).
11. Install the replacement oil filter to the filter
adapter. Turn the oil filter clockwise until
the rubber gasket contacts the filter adapter,
27