Toro 22317, Руководство оператора

Страница: 21 / 44

Using the Cylinder Locks
The loader arms may lower when in the
raised position crushing anyone under them.
Install the cylinder locks before performing
maintenance that requires raised loader
arms.
Installing the Cylinder Locks
1. Start the engine.
2. Raise the loader arms to the fully raised
position.
3. Stop the engine.
4. Position a loader arm cylinder lock over each
lift cylinder rod (Figure 11).
5. Secure each loader arm cylinder lock with a
clevis pin and cotter pin (Figure 11).
Figure 11
1. Cylinder lock 4. Clevis pin
2. Lift cylinder 5. Lift cylinder rod
3. Hairpin cotter
6. With the engine off, lower the loader arms.
Removing/Storing the Cylinder Lock
1. Start the engine.
2. Raise the loader arms to the fully raised
position.
3. Stop the engine.
4. Remove the clevis pin and cotter pin securing
each cylinder lock.
5. Remove the cylinder locks.
6. Lower the loader arms.
7. Install the cylinder locks over the hydraulic
hoses and secure them with the clevis pins and
cotter pins (Figure 12).
Figure 12
1. Hydraulic hoses 3. Hairpin cotter
2. Cylinder locks 4. Clevis pin
Using Attachments
Installing an Attachment
Important:
Use only Toro-approved
attachments. Attachments can change the
stability and the operating characteristics of
the traction unit. The warranty of the traction
unit may be voided if used with unapproved
attachments.
Important:
Before installing the
attachment, ensure that the mount plates are
free of any dirt or debris and that the pins
rotate freely. If the pins do not rotate freely,
grease them.
1. Position the attachment on a level surface with
enough space behind it to accommodate the
traction unit.
2. Start the engine.
3. Tilt the attachment mount plate forward.
4. Position mount plate into the upper lip of the
attachment receiver plate (Figure 13).
21