Toro 22045, Руководство оператора

Страница: 8 / 24

8
Install Gas Tank And Fuel Line
1. Start self–tapping screws into bottom of gas tank and
then remove screws.
2. Hook plastic clips on front of gas tank onto gas tank
bracket (Fig. 3).
3. Secure gas tank to tank base with the (2) self–tapping
screws (Fig. 3). Do not overtighten screws.
4. Hook gas tank retainer onto rear of gas tank and slide
end of retainer into hole in tank bracket. Secure
retainer to tank bracket with locknut (Fig. 3). Do not
overtighten locknut.
m-2942
1
2
3
4
6
5
7
Figure 3
1. Self-tapping screws
2. Gas tank
3. Plastic clips
4. Gas tank retainer
5. Gas tank bracket
6. Lock nut
7. Tank base
5. Remove red cap from end of fuel line and from end of
elbow fitting on gas tank. Slide end of fuel line onto
elbow fitting (Fig. 4). Secure fuel line in place with
fuel line clamp.
m-2943
1
2
3
Figure 4
1. Fuel line
2. Elbow fitting
3. Fuel line clamp
Install Air Cleaner Cover
1. Insert bottom tabs of air cleaner cover into slots.
Rotate cover upwards and snap into place (Fig. 5).
m-196
1
2
3
Figure 5
1. Cover
2. Tabs
3. Slots
Install Discharge Tunnel Plug
1. Open the discharge door by pulling forward on the
handle and moving it rearwards (Fig. 6). Hold the
discharge door handle to prevent the spring–loaded
door from closing while inserting the plug.
2. Since the plug is slightly wider than the discharge
tunnel opening, rotate the plug clockwise slightly
while inserting it (Fig. 6). Make sure the arrow on the
plug decal is pointing upwards.
m–1914
2
1
Figure 6
1. Discharge door handle 2. Plug rotated clockwise
3. Push the plug all the way in until the spring clip on the
bottom of the plug clicks into place, locking the plug
securely into the discharge tunnel (Fig. 7). Release
discharge door handle to lock top of plug.