Toro 08731, Руководство оператора

Страница: 3 / 16

Figure 1
1. Right-hand wheel shroud 4. Screen panel
2. Nut (2) 5. Screws
3. Bolt and washer (2)
3. Remove and retain the shroud.
Note:
If a Manual Blade (Model 08714) is installed on
the machine, remove the right blade-mounting bracket
before installing the lift arm assembly.
4. Remove the 2 screws, 2 bolts, 2 washers and 2 nuts that
secure the screen panel to the frame (Figure 1).
Note:
Remove and discard the screen panel, but retain
the washers and nuts.
5. Install the mounting bracket of the scarifier lift-handle
assembly to the right footrest tubes with 2 bolts (1/2
x 3-1/4 inch) and thin locknuts (1/2 inch), as shown
in Figure 2.
Figure 2
1. Bolt (1/2 x 3-1/4 inch) 4. Thin locknuts (1/2 inch)
2. Mounting bracket 5. Footrest tube
3. Scarifier lift-handle
assembly 6. Hydraulic line
Note:
Ensure that the bolt heads are positioned to the
outside and that the thin locknuts are used.
Important:
There are both thick and thin locknuts
in the loose parts. Use the thin locknuts for this
step. If you use the thick ones, they will not lock
on and will eventually fall off.
Note:
The handle assembly is installed through the
bottom of the traction unit by guiding the handle up
through the opening made by removing the screen
panel.
Note:
Do not disassemble the handle assembly to
install it into the traction unit.
6. Insert the detent plate onto the scarifier lift handle.
Note:
The handle should pass between the detent
plate and the handle guide (Figure 3).
8
G019398
Figure 3
1. Locknut (5/16 inch) (2) 5. Scarifier lift handle
2. Right rear frame tube
6. Knob
3. Detent plate 7. Washer (2)
4. Handle guide 8. Bolt (5/16 x 2-1/4 inch) (2)
7. Install the detent plate to the back of the right rear
vertical frame tube with 2 bolts (5/16 x 2-1/4 inch), 2
washers, and 2 locknuts (5/16 inch) (Use the washers
and locknuts removed in step 4). Position the parts as
shown in Figure 3.)
8. Thread the knob onto the lift handle (Figure 3).
9. Ensure that the lift handle moves the full range of
motion through the detent plate and that it locks into
place at each detent location.
Note:
If the lift handle is too loose or too tight,
tighten or loosen the locknuts on the handle lift pivot
(Figure 4).
3