Toro 08102, Руководство оператора

Страница: 81 / 104

Checking and Adjusting the
Alternator Belt
Service Interval: After the first 50 hours—Check and
adjust the alternator belt.
Every 250 hours—Check and adjust the
alternator belt.
1. Press the belt inward using your finger or a ruler
with a force of approximately 98 N (22 lbf) to
check the deflection.
There are 3 positions to check the belt tension
(
Figure 88 ). The correct deflection at each
position is as follows:
•
Position 1— 9 to 13 mm (5/16 to 1/2 inch)
•
Position 2— 7 to 10 mm (1/4 to 3/8 inch)
•
Position 3— 10 to 14 mm (3/8 to 1/2 inch)
g366704
Figure 88
1. 9 to 13 mm (5/16 to 1/2
inch) 3. 10 to 14 mm (3/8 to 1/2
inch)
2. 7 to 10 mm (1/4 to 3/8
inch)
2. If needed, adjust the belt tension as follows:
3. Loosen the adjusting bolts and nuts, then move
the alternation using a wrench to tighten the belt
to the correct tension (
Figure 89 ).
4. Tighten the adjusting bolts and nuts ( Figure 89 ).
g366768
Figure 89
1. Adjusting bolt 3. Wrench
2. Alternator
5. Tighten the belt to the correct tension.
Ensure that there is clearance between the belt
and the bottom of the pulley groove. If there is
no clearance between the belt and the bottom of
the pulley groove, replace the belt (
Figure 90 ).
g366767
Figure 90
1. Example of clearance
between the belt and
the bottom of the pulley
groove
2. Example of no clearance
between the belt and
the bottom of the pulley
groove
6. Check the belt for cracks, oil, and/or wear.
Replace, if necessary.
81