Toro 08102, Руководство оператора

Страница: 54 / 104

Seat Belt Indicator
The seat belt indicator illuminates when the operator
does not have their seat belt fastened.
Note:
If the seat belt is not fastened, the machine
speed will be limited.
Fault Code Indicator
The fault code indicator illuminates and the
corresponding fault code number appears when a
machine fault occurs.
Important:
Do not operate the machine if a fault
code appears; otherwise, serious damage could
occur. Contact your authorized Toro distributor.
Hour Meter
The hour meter indicates the total hours of machine
operation. The hour meter (
Figure 62 ) starts to
function whenever the engine is running.
Oil-Pressure-Warning Light
The oil-pressure-warning light ( Figure 62 ) illuminates
if the engine-oil pressure drops below a safe level
while the engine is running.
Important:
If the light flickers or remains on,
stop the machine, shut off the engine, and check
the oil level. If the oil level is low, but adding
oil does not cause the light to go out when the
engine is started, shut off the engine immediately,
and contact your authorized Toro distributor. for
assistance.
Check the operation of the warning light as follows:
1. Ensure that the machine is in the P (P
ARK
)
position.
2. Turn the key switch to the O
N
/P
REHEAT
position,
but do not start the engine.
Note:
The oil-pressure light should illuminate.
If the light does not turn on, then there is a
potential malfunction in the display and/or signal.
Note:
If you just started or shut off the engine,
it may take a few seconds for the light to turn
off or on.
Coolant-Temperature Gauge and
Light
The coolant-temperature gauge registers the coolant
temperature in the engine and operates only when the
key switch is in the O
N
position ( Figure 62 ).
The 8 coolant bars blink and a fault code appears if
the engine overheats.
Charge Indicator
The charge indicator illuminates when the battery
discharges. If the light illuminates during operation,
stop the machine, shut off the engine, and check for
possible causes, such as the alternator belt (
Figure
62 ).
Important:
If the alternator belt is loose or
broken, do not operate the machine until the
adjustment or repair is complete. Failure to
observe this precaution may damage the engine.
Check the operation of the warning lights as follows:
•
Shift the transmission lever to the P (P
ARK
)
position.
•
Turn the key switch to the O
N
/P
REHEAT
position,
but do not start the engine. The coolant
temperature, charge indicator, and oil-pressure
lights should glow. If any light does not function,
there is a malfunction in the system that you must
repair.
Fuel Gauge
The fuel gauge shows the amount of fuel in the tank.
It displays only when key switch is in the O
N
position
( Figure 62 ).
A single bar indicates a low fuel level and 1 flashing
bar indicates that the fuel tank is nearly empty.
Tachometer
The tachometer displays the speed of the engine
(
Figure 62 ).
Speedometer
The speedometer registers the ground speed of the
machine (
Figure 62 ).
Display Button/Ground Speed
Governor Control
Press the button ( Figure 62 ) between 0 to 3 seconds
to swap the locations of tachometer and speedometer.
Press and hold the button ( Figure 62 ) between 3 to
10 seconds to convert the speedometer from mph to
km/h.
Press and hold the button for 10 seconds or more to
adjust the ground speed governor; refer to
Adjusting
the Ground Speed Governor (page 64) .
Check-Engine Light
The check-engine light illuminates to indicate an
engine malfunction; refer to
Troubleshooting (page
100) .
54