Toro 07344, Руководство оператора

Страница: 9 / 24

4
Mount the Parking Brake
Switch
Parts needed for this procedure:
1 Parking brake switch
2 Screws
Procedure
1. Mount the parking brake switch to the parking brake
mount with two screws as shown in Figure 5.
Figure 5
1. Switch
2. Plug switch wire connector into lift wire connector
harness.
3. Remove the loop back connector from the vehicle
wire harness labeled 1/3 lift. Connect the lift wire
harness to the vehicle wire harenss.
5
Mount Rear Level Switch
Parts needed for this procedure:
1 Rear level switch bracket
1 Rear level switch w/ harness
For Workman 3000–4000 series
vehicles with serial numbers 240000001
and up
1. Remove locknuts securing hitch plate to rear axle
(Figure 6). Using the upper set of mounting holes,
loosely mount the level switch bracket to rear axle
with locknuts removed.
Figure 6
1. Hitch plate 3. Switch harness
2. Level switch bracket
2. Route switch harness forward, along differential
lock cable to left side of machine. Harness must not
interfere with any hot (exhaust) or moving parts.
Secure harness to differential lock cable with cable
ties.
For Workman HD, HDX and HDX-D
vehicles
1. Remove capscrews securing hitch plate to rear axle
(Figure 7). Using the lower set of mounting holes,
loosely mount 2 washers and level switch bracket to
rear axle with capscrews removed. The washers are
to be positioned between the hitch plate and axle.
9