14
ATTENTION:
Every type of floor requires a
specific adjustment. For example,
concrete floors (where the friction
tends to be high) need little pres-
sure, while smooth floors (ceram
-
ics) need higher pressure.
If the cleaning operations are
always made on the same type of
floor, the adjustment can change
only as the rubbers wear.
Splash guard assembly
The two splashguards have to be
assembled onto the brush base
group. Insert the metal strips inside
the suitable slots on the rubber.
Place the round hole at the flat
end of the strip onto the screw
(1) placed in the front part of the
brush base group. Secure the strips
through the nut locking it.
Lock the coupling levers (2) in the
rear part of the brush base group to
the rings placed at the ends of the
metal strips still free. Repeat for the
other splashguard. Ensure that the
gap between the two rubbers in the
front part of the brush base group is
to reduced to a minimum.
With brush assembled, the splash-
guard must slightly touch the floor.
Brush assembly
The machines that have the electri-
cal brush base lifting:
1. Switch on the machine by turn-
ing the key (9) clockwise.
2. Press the push button (7) of up/
down brush base to lift the brush.
3. Turn off the unit by turning the
key (9) counterclockwise
ATTENTION:
To carry out brush assembly opera-
tions with the electric supply on,
may cause damages to hands.
With the brush base group in lifted
position, insert the brush into their
plate seat underneath the brush
base turning them until the three
metal buttons are properly seated
in their slots; rotate the brush to
push the button towards the cou-
pling spring until they are locked in
place.
The figure shows the rotating direc
-
tion for brush coupling.
We suggest to daily alternate the
brush position for a longer brush
life. Whenever a brush becomes
deformed, we suggest installing
them in the same position. This will
avoid motor overload or vibrations
from the different inclination of the
bristles.
ATTENTION:
Use only brush supplied with the
machine or the ones indicated in
the paragraph “RECOMMENDED
BRUSH”. The use of other brush
can compromise security.
Floor Cleaning
Connecting the batteries to the
machine Once the battery charging
has been completed:
1. Disconnect the connector (3)
from the battery charger (1).
https://harrissupplyind.com - To Order Parts Call 608-268-8080
