Tornado 99726, Руководство по эксплуатации и техническому обслуживанию, Страница: 19 / 24

19
2. Release the hook (9) of the
rubber blade holder and take the
rubber off.
3. Turn the rubber to a new side or
replace it.
To reassemble the squeegee,
reverse the operations above
inserting the rubber on the guides
and locking it with the rubber
blade holder.
Squeegee hose cleaning
Weekly, or in case of insufficient
suction, it is necessary to check
that the squeegee hose is not
clogged. To clean it, proceed as
follows:
1. Take off the hose (1) from the
squeegee coupling.
2. Wash the inside of the hose
with a water jet.
To reassemble the hose reverse the
operations above.
ATTENTION:
Do not wash the hose that goes
from the suction motor to the
suction cover while it is connected
to the suction motor connection.
Cleaning of the solution tank
1. Bring the machine to an
appropriate place for the solution
draining.
2. Unscrew the solution tank cap.
3. Unscrew the solution drain cap
(1).
4. Allow the solution to flow out
into appropriate containers.
Pay close attention not to lose
the gasket of the cap.
5. Rinse the solution tank with a
water jet.
6. Reassemble all parts.
ATTENTION:
This operation must be carried out
using gloves to protect from
contact with dangerous solutions.
Cleaning of the solution filter
1. Empty the solution tank as
indicated in paragraph
“CLEANING OF THE
SOLUTION TANK”.
2. Unscrew the cap of the exhaust
filter (1).
3. Rinse the filter placed inside the
cap, paying close attention not to
lose the gasket of the cap.
4. Rinse the hose by pouring some
water into the solution tank.
5. Reassemble all parts.
ATTENTION:
This operation must be carried out
using gloves to protect from
contact with dangerous solutions.
Two-month maintenance
Front squeegee rubber check
Check the wear of the front
squeegee rubber replace it when
needed.
For the replacement it is necessary
to:
Release the squeegee from the
support as indicated in paragraph
"SQUEEGEE CLEANING".
Unscrew the wing nuts in the front
part of the squeegee.
Take off the rubber holder blade.
Replace the front rubber. Reas-
semble all parts.
Six-month maintenance
Splash guard rubber check
1. Open the hooks in the rear part
of the brush base group from the
slot placed at the end of the metal
strip.
2. Replace the splashguard
rubbers and follow assembling
instructions as under paragraph
“SPLASH GUARD
ASSEMBLY”.
With brush assembled, the
splashguard must slightly touch the
floor.
https://harrissupplyind.com - To Order Parts Call 608-268-8080