18
ATTENTION:
This operation must be carried out
using gloves to protect from
contact with dangerous solutions.
Suction filter cleaning
1. Take off suction cover (2) after
rotating the locking levers (1).
2. Take off the filter and filter
protection.
3. Clean all parts with a water jet
especially the inside surfaces and
the filter bottom. 4. Reassemble all
parts.
Brush cleaning
Disassemble the brush and clean
them with a water jet (check under
paragraph of “BRUSH
DISASSEMBLY”).
Brush disassembly
For machines that have the
electrical base brush lifting:
1. Switch on the machine by
turning the key (9) clockwise.
2. Press the push button (7) of
up/down brush base to lift the
brush.
3. Remove the electric supply by
turning the key (9)
counterclockwise.
ATTENTION:
To carry out brush disassembly
operations with the electric supply
on, may cause damages to hands.
With the base brush in lifted
position, turn the brush as
indicated in the figure, until it is
released from the brush holder
plate seat. The figure shows the
direction for brush release.
ATTENTION:
Pick up the brushes and wash them
using gloves to protect from
contact with dangerous solutions.
Squeegee cleaning
Keeping the squeegee clean
guarantees the best drying action.
For cleaning it is necessary to:
1. Take off the squeegee hose (5)
from the coupling.
2. Disassemble the squeegee (2)
from its support (1) by rotating the
lever (4) counterclockwise and
sliding the squeegee to the right to
release the stud bolts (3) from their
slots.
3. Clean with care the internal part
of the squeegee inlet and rubbers.
4. Reassemble all parts.
Weekly maintenance
Rear squeegee rubber check
Check the squeegee rubber wear
and eventually turn or replace it.
For the replacement it is necessary
to:
1. Lift the squeegee assembly by
pulling up on the lever (17).
https://harrissupplyind.com - To Order Parts Call 608-268-8080
