Torgun TB-20, Инструкция по эксплуатации

Страница: 8 / 12

8
Apply adhesive into the slot formed in one of the
wing halves and slide the wooden dihedral brace -
wing joiner firmly in position.
Ensure joiner is flush with top surface of wing. Wipe
off any excess adhesive and allow to dry.
Apply adhesive to the wing root and dihedral brace
slot in the remaining wing panel.
Slide the wooden dihedral brace - wing joiner in
position while butting the panels together.
Ensure that the wing halves are correctly aligned
with no visible gap and use tape or clips to hold in
place.
Wipe off any excess and adhesive allow to dry.
Locate the leading edge dowel plate and test fit in
the recess at the front of the wing.
When happy with location apply adhesive and press
firmly in place.
Locate the aileron servo with its pushrods and
connectors.
Apply a drop of adhesive to each side of the servo
and push into recess formed in wings.
The servo shaft should be central in the wing with
the lead exiting as shown
Connect the pushrods to the aileron control horns.
Push the servo arm onto the servo output shaft but
do not screw in place at this time.
Locate the main undercarriage assemblies, saddle
plates and fixing screws.
Insert undercarriage into mounting plate and fix in
place with saddles and four self tapping screws.
Locate the fuselage, horizontal stabiliser and two
fixing screws.
Position over the tail plane seat and tighten screws
securely.