Topview Kestrel 3100m, Инструкция по установке, техническому обслуживанию и эксплуатации

Страница: 17 / 52

- 13 -
equipment, and if the equipment is idle for a long run, it's better to turn off the power switch.

Power switch

Power switch is used to connect and disconnect the equipment's power supply, with "
∣
"
meaning "connected" and "○" meaning "disconnected". Power cord interface is the port for
external power cords. Power cord interface is set next to the protective tube.

Base

The base is mainly used to support the head and control the three-dimensional movement of
head.

Peripheral interface

Peripheral interface refers to the interface connecting with external equipment, consisting of
three kinds: USB interface, DVI interface and net interface.

USB interface: USB 2.0 interface or above, which is mainly used to update software, save
data and print reports; In case of any fault in the touch screen, data shall still be input via
connecting USB2.0 supportive keyboard and mouse.

DVI interface: DVI-D format interface, which is mainly used for data output by connecting
to the external display in case of any fault of LCD touch screen.

Network interface: Disabled currently (reserved interface for software upgrade in the future),
RJ-45 Ethernet interface, following IEEE802.3 Standards.

The power cord interface is located at the bottom right part of head base. Power cord
interface is the port for external power cords.
3 Basic operation
This chapter is intended to introduce the basic operation procedures when operating
RetiCam3100 for data acquisition.
3.1 Equipment startup
1) Connect the power cords, turn on the power switch, and press the computer switch to start it up.
2) Have patient's head firmly rested on the chin rest and forehead rest of fundus camera. Align and
focus the camera on the fundus of the patient. Making sure the comfort of every patient can be
beneficial to achieve the stability needed for capturing clear fundus images.
3.2 Information input module
(1) Input patient information
Fill in the patient information in "Patient Information" list (ID number will be generated
automatically upon clicking). Then click [Save]. In case of re-write completely, the operator shall
click "New Folder" or "Anonymous Patient", and then click "Save" after filling out the
information.