TOPP M200, Инструкция по установке и эксплуатации

Страница: 7 / 32

7
instructions for installation
M200
ARTICULATED PUSHING ARM INSTALLATION
AUTOMATION INSTALLATION
M200 with articulated
pushing arm
DRILLING HOLES
1. With a suitable drill, make the 6 holes as
per the position specifications and insert
the 6 anchors in the wall holes
2. Mark the 2 fixing points for the arm
bracket
PLATE FITTING
1. Fasten the mounting plate with the fixing
screws securely.
2. Prepare the input for the electrical wires
AUTOMATION FITTING
1. Position the electric wires inside the
automation.
2. Fit the unit and tighten the 8 nuts to
secure the automatio
ARM ASSEMBLY
1. Assemble the arm with the dowel as
shown in the figure
2. If the application required, insert the axle
extension
ARM ADJUSTMENT
1. Fix the arm bracket to the door with two
appropriate screws in the holes previ-
ously drilled
2. Loosen the two screws for the arm length
adjustment
3. Make sure the door is closed, position
the extendable lever of the arm at a
90°angle from the door, adjust the arm
length and tighten the two adjustment
screws
ARM FITTING
1. Apply the supplied glue to the upper part
on the outer conical surface of the pin,
making a circumference all around the
pin
2. Make sure the door is closed, Insert the
pivot pin of the arm in the housing on the
actuator, taking care to have previously
fitted the plastic cover (ref.a)
3. insert the fastening screw of the arm in
the motor axis and tighten with torque
of 38Nm and screw the extractor cover
cap(ref. b) on the arm.
3
a
b