TOPP M200, Инструкция по установке и эксплуатации

Страница: 11 / 32

11
3
a
b
AUTOMATION INSTALLATION
M200 with pulling sliding
arm-elbow
DRILLING HOLES
1. With a suitable drill, make the 6 holes as
per the position specifications and insert
the 6 anchors in the wall holes
2. Mark the 2 fixing points for the arm
bracket.
PLATE FITTING
1. Fasten the mounting plate with the fixing
screws securely.
2. Prepare the input for the electrical wires
AUTOMATION FITTING
1. Position the electric wires inside the
automation.
2. Fit the unit and tighten the 8 nuts to
secure the automatio
SLIDING GUIDE ASSEMBLY
1. If the application required, insert the axle
extension
2. Assemble the axle 90° elbow arm
3. Grease the runner, then fit the guide in
the runner taking care to leave the two
larger holes on the outside.
SLIDING GUIDE FITTING
1. Fix the sliding guide with two appropriate
screws in the holes previously drilled
2. Fit the caps in the front holes
3. Fit the lateral caps of the guide
ARM FITTING
1. Apply the supplied glue to the upper part
on the outer conical surface of the pin,
making a circumference all around the
pin
2. Insert the pivot pin of the arm in the hous-
ing on the actuator, taking care to have
previously fitted the plastic cover (ref.a)
3. Make sure the door is closed, insert the
fastening screw of the arm in the motor
axis and tighten with torque of 38Nm and
screw the extractor cover cap (ref.b) on
the arm
instructions for installation
M200
SLIDING PULLING ARM INSTALLATION - ELBOW