TOPMAQ MM3156, Руководство по эксплуатации для владельца

Страница: 26 / 32

２５
4. Using the supplied 6 mm hex wrench key, remove both conveyor table
mounting bolts on the outboard open side of the wide drum sander (See
Figure
11 in the Drum Alignment section for reference.)
5. Reduce tension on the conveyor feed belt by rotating both the inboard and
outboard conveyor feed belt tracking adjustment screws in a
counterclockwise direction. (See Figures 14 and 15 in the Conveyor Feed
Belt Tracking Adjustment section for reference.)
6. Remove the used conveyor feed belt by grasping both sides of the belt as
shown in Figure 21. Gently lift the conveyor table as you slide off the
conveyor feed belt. If the belt will not move, further
reduce the tension on
the feed belt and ensure you are lifting the table high enough to allow the
feed belt to slide off .
7. To install the replacement conveyor feed belt, follow Steps 6 through 3 in
reverse order. Center the new feed belt on the conveyor feed belt table
and evenly tension the new feed belt using the inboard and outboard
tracking adjusters. If you have experience tracking problems, consult the
Conveyor Feed Belt Tracking Adjustment section .