TOPMAQ MM3156, Руководство по эксплуатации для владельца

Страница: 13 / 32

１２
Figure 7
4. Secure the assembled Wide
Drum Sander to the accessory workstand
or to an adequately stable workbench or stand before operating the machine.
WARNING: To prevent possible serious personal injury, always disconnect the
Wide Drum Sander from the power source before servicing the unit or
changing the abrasive strips.
WARNING: For your own safety, never connect the plug to a source outlet
until you have read and understood the safety and operating instructions for
your Wide Drum Sander.
WARNING: Make certain that the switch is in the OFF position before inserting
the plug into a power source. Do not connect the power until you are ready to
operate the machine. Be sure that the bolts are firmly tightened before
connecting the machine to power source.
CAUTION: The surface to which the Wide Drum Sander is mounted must not
be warped or uneven. Mounting the base to a warped surface will cause
distortion and poor operation.
ADJUSTMENTS
Your Wide Drum Sander was aligned and completely adjusted during
assembly. However, due to stresses imposed on the unit during shipment, you
may need to adjust or align your unit or return it to perfect alignment. It is very
important that the following adjustments be performed as described.
WARNING: Never make any adjustments with the unit connected to the power
source. Failure to heed this warning can result in serious personal injury.
WARNING: Always secure tool to workbench or workstand to avoid tendency
for tool to tip over, slide, or walk on the supporting surface. Failure to secure
tool can result in serious personal injury.
SANDING DRUM DEFLECTION
Before beginning the sanding drum alignment procedures outlined in the
following section, ensure that minimal upward deflection of the sanding drum
occurs when sanding. The three primary causes of excessive sanding