TOPMAQ MM3156, Руководство по эксплуатации для владельца

Страница: 17 / 32

１６
Conveyor Table Mounting Bolts
Figure 11
2. Slide one or both of the shims (not supplied) as needed under the edge of
the conveyor
table as shown.
3. Tighten conveyor table mounting bolts. Re-check the measurement at A
and at B.
4.
Sand a piece of wood and check for uniform thickness.
If the measurement at A exceeds B by more than .020”, or if distance B is
greater than A, proceed as follows:
1. Loosen the two front and two rear
adjustment bolts as shown in Figure 12,
thus allowing the entire drum assembly to pivot.