Topens A3132, Руководство пользователя

Страница: 29 / 35

26
Note: The position of Limit Switch A was fixed
in factory, do not adjust it again.
1 For Pull-to-Open Installation, adjust the
limit switch B to determine the closed
position:
Turn on power to operate the gate opener,
then the arm extends to close the gate.
If the arm closes over the desired closed position, press the remote control to stop the opener. Use a screwdriver to
loosen the screw of the limit B, slightly slide the limit switch B
inwards.
If the arm closes halfway and fails to get to the desired closed position, slightly slide the limit switch B outwards.
Please repeat the above steps, until the arm could arrive and automatically stop at the desired close position. Then
tighten the screw firmly.
Limit setting for master gate is finished now. The slave gate is totally the same.
2 For Push-to-Open Installation, adjust the limit switch B to determine the open position:
Turn on power to operate the gate opener, then the arm extends to open the gate.
If the arm opens over the desired open position, press the remote control to stop the opener. Use a screwdriver to
loosen the screw of the limit B, slightly slide the limit switch B
inwards.
If the arm opens halfway and fails to get to the desired open position, slightly slide the limit switch B outwards.
Please repeat the above steps, until the arm could arrive and automatically stop at the desired open position. Then
tighten the screw firmly.
Limit setting for master gate is finished now. The slave gate is totally the same.
Setting of the Control Board
WARNING: Ensure the gate opener is Power Off when you make any adjustment of the gate opener.
Keep away from the gate during you set the gate opener system in case of the unexpected gate moving.
Carefully adjust the DIP switches to avoid the risk of machine damage and injury or death. Always ask
the help of professional technician /electrician if you have any question.
1. DIP Switches
The DIP switches are used to select pull/push to open, enable/disable auto close function, enable/disable open
interval between the master and slave gate opener, enable/disable close interval between the master and slave
gate opener and enable/disable photo beam function.