TOP CNC
Machine No: DB1802020101
Machine Model: TC-1631A
7
1. Connect fittings to inlet of pump.
2. Connect the additional fitting to the T connection.
3. Install the filter.
4. Connect the vacuum hose from the filter to the machine and secure with hose clamps.
5. Remove electrical lid and connect electrical wires. Refer to wiring diagram on the inside of the lid for
proper installation.
6. Plug the cable into the electrical cabinet and supply power. Verify that air is being exhausted from the
outlet of the pump. If not immediately disconnect the pump from the cabinet and change any two of
the three connected live wires. BE SURE TO DISCONNECT POWER BEFORE ADJUSTING
CONNECTIONS!
7. To test the suction power of the pump place a 100mm x 100mm piece of wood over the air inlet and if
the board remains suctioned to the pump the suction is sufficient.
8.
Install sealing strip on the vacuum table. The area of the sealing strip should be the same as the size of
material being cut.
6. Install the Dust collector
(Note: Before power on, check whether the voltage is consistent);
1.Remove the dust collector from the package and install it according to the instructions of the dust
collector.
2.Connect the dust collector to the machine connection.
3.Connect the other end of the power cord to dust collector motor.
