20
km / h.
C: When the user's heart rate is lower than the target heart rate 6-29 beats / min, the speed is increased 1.0
km / h.
D: When the user's heart rate is higher than the target heart rate 30 beats / min, the speed is decreased 2.0
km / h.
E: When the user's heart rate is higher than the target heart rate 6-29 beats / min, the speed is decreased
1.0 km / h.
F: When the user’s heart rate is higher or lower than the target heart rate 0-5 beats/min, the speed won’t
change.
8.4. According to the following situation, the treadmill will be slow down to the lowest speed in 20 seconds, and
then stop after running 15 seconds in the lowest speed and sound once per second.
A: Can’t check the heart rate one minute.
B: The heart rate will decrease speed in the lowest speed 1.0 km / h (0.6m / h).
C: The heart rate is higher than (220- age).
8.5. You can not decrease speed lower than the lowest speed when above the lowest speed, For example: the
lowest speed is 1.0km / h, it will be 1.0 km / h when you decrease speed from 1.6 km /h to 1.0 km / h.
8.6. The inclination isn’t controlled by the heart rate, it can be adjusted manually. The initial speed is 1.0km/h, it
can’t be adjusted speed by heat rate before one minute you are running.
(
Ⅸ
).Step counting
9.1. After starting the treadmill, check the size of the current changes of motor. And the steps are diaplayed in the
corresponding “
STEP
” window through the internal calculation formula.
9.2. Caution
：
The following factors may affect thr accuracy of the step count: ways of walking, weight and
characteristics of usage. For example, step counting system is difficult to measure the number of users with
light weight (weight less than 110 pounds or 50kg, or speed less than 1MPH or 1.6 km/h).
9.3. Presentation
：
Display of steps is genernally 1-9999. After 9999 steps, the format will change. Users should
add one 0 to the number of display. For example, the 1001=10010 step, 1505=15050 step, 2005=20050
step is displayed.
(
Ⅹ
). Automatic shutdown
After running 5 minutes, no running is detected and the treadmill automatically stops to prevent accidents
andsave energy.
(XI).Lubrication message “LUB”
A: When the total workout distance of treadmill reach 2000KM, the console will display message “LUB” to remind user the
running belt should be lubricated. And in the right bottom corner of display window, it will show number 01 to 99. It is the
accumulated times that this message displayed.
B. The treadmill could work normally even it shows “LUB” message. But the “LUB” message will keep flashing on
display when the user runs on it.
C. After lubricated the treadmill by manual, when treadmill is in standby mode, user could press key “P” and “STOP” for 5
seconds at the same time to clean “LUB” message. And the distance 2000KM for lubration will be recount.
