Toolex 597078, Инструкция по эксплуатации

Страница: 15 / 20

15
5. If the unit repeatedly shuts down from thermal overload, stop all use. Have the Air
Plasma Cutter inspected and repaired by a qualified service technician.
6. Store the welder and accessories in a clean and dry location.
7. Periodically disassemble and clean the Torch Head components with steel wool.
Replace burnt, cracked, distorted, or coated components, Refer to the assembly
drawing on page 11.
8. To gain access to the internal components of the unit, remove screws from Main Body
Cover. The home user is strongly advised not to remove the tool covers and not to
attempt any electronic repairs. Any repairs must be completed by a qualified
technician. Opening the tool will void any warranties, and may result in damage to
equipment or possible personal injury. Don’t do it.
9. On a daily basis check for any of the following problems: If any are found, take the tool
to a qualified repair technician.
a. Abnormal vibration, sound or smell.
b. Abnormal heating at any cable connection.
c. Then fan does not work properly.
d. Any switch or control does not work properly.
e. Any damage to cables.