Toolex 597078, Инструкция по эксплуатации

Страница: 10 / 20

10
especially the section “Specific Safety
Rules” starting on page 3.
1. Mount the metal to be cut to the metal
weeding-cutting table. It should be
mounted so that the cutting debris falls
to the cement floor.
2. Place the Air Plasma Cutter unit no
closer than six feet from the
workpicece to be cut.
3. Securely place the clamping end of
the Grounding Cable Clamp to a part
of the workpiece or metal table that is
clean of paint, oil, or dirt. Clamp as
close as possible to the workpiece
without damaging the cable during
cutting.
4. Verify that the Power Switch is in the
Off (O) position, then plug the
120V~line
cord plug into an
appropriate 120V~outlet.
5. When everything is in place for cutting,
press the Power Switch UP to the ON
position. The Power Light” WILL
illuminate, but the Torch is not yet
energized.
6. Orient yourself to one side of the area
to be cut, and move the Welding
Helmet Face Shield (not included,)
over your eyes.
7. BE CAREFUL! PILOT PLASMA ARC
CAN SEVERELY INJURE. Once the
trigger is squeezed, the arc will
ignite. This unit provides a pilot arc,
so the torch does not need to
contact the work piece before the
cutting arc ignites.
8. (Refer to parts diagram above for
Torch Handle components.) Direct
torch away from people and
flammables
while you squeeze (and
hold) the Torch Handle Trigger (2A) to
energize the Torch Electrode (4A).
The air output is delayed a few
seconds to enable a proper arc to
begin.
Caution : The Torch handle is now
energized. Be careful not touch anything
else with the Torch except the work piece
to be cut.
Warning: Never look at the ignited arc
without the approved, arc shaded, eye
protection in a full face shield. Permanent
eye damage or blindness can occur, also
Skin burns can occur. Never breathe arc
fumes.
The pilot arc starts immediately
when trigger is pressed.