Toolex 597078, Инструкция по эксплуатации

Страница: 11 / 20

11
"
丨
\\
Pause briefly at
end of cut before
releasing trigger.
/ / l \ \
Adjust speed so
sparks go thru metal
and out bottom of cut.
"
丨
\\
Pause briefly at
end of cut before
releasing trigger.
/ / l \ \
Adjust speed so
sparks go thru metal
and out bottom of cut.
Maintain approximately a 90° angle to the
work piece
If sparks flare back from surface,
this usually is an indication that
travel speed is too fast.
Pulling rather than pushing the
torch makes cutting easier. Use a
proper guide or template for
accurate cutting operations.
DO NOT put pressure on shield
when drag cutting; instead, slide
shield along the surface for
proper cutting results.
Sparks should pass through
the work piece surface for
proper cutting results.
and out the bottom when cutting
Move torch to upright
position 90
°
to surface.
Start cutting when arc
pierces work piece.
Maintain torch position
and continue cutting.
Release trigger. Post flow cooling
Continues after releasing trigger
Post flow must finish before
Trigger will restart pilot
arc.
Place tip near work.
Keep tip 1/16 in.
From work
For max cutting
Speed and tip
life.
Torch air cooling (post flow) continues after
releasing trigger.
Post flow must finish before trigger will
restart pilot arc.
"
丨
\\
Pause briefly
at end of cut
before
releasing
trigger.
/ / l \ \
Adjust speed so sparks go thru
metal and out bottom of cut.