EN – V1 - P5
OPERATION & USE Κ
SYSTEM TEST - NBT200 (test for 12V systems)
FOR STARTER SYSTEM TEST
1.
LED display will light on and show the voltage of the battery XX.XX on the
screen. Press “ENTER” to the next step.
NOTE
: If you see
H
/
Lo
/ ---- /
Blank
appeared on the screen or
screen flickers, please refer to TROUBLESHOOTING.
2-A.
Please press
▲\▼ key to select the system test: SySt. Press
“ENTER” to the next step.
2-B.
Please press
▲\▼ key to select the battery test (NBT100): bAtt.
Press “ENTER” to the next step.
3.
Turn off all vehicle accessory loads such as light, air conditioning,
radio, etc. before starting the engine.
4.
The screen shows CrAn. Press “ENTER” bottom to read the
minimum voltage of the battery.
5.
Start the engine. Read the voltage after cranking the starter.
A.
Green LED lights. = Starting system ok.
B.
Yellow LED lights. = Starting system weak. Check connections,
wiring, and starter.
C.
Red LED lights, the screen shows blank or the screen shows the
voltage of the battery XX.XX
= Starting system problem. Check connections, wiring, and starter
immediately.
FOR CHARGING SYSTEM TEST
1.
After starter test, press “ENTER” bottom to go to charging system test,
the screen shows CHAr. press “ENTER” bottom to read live voltage.
2.
Run up the engine to 1200 ~ 1500 rpm. Read the voltage while the car
is running.
A.
Green LED lights. = Charging system ok.
B.
Red LED lights = Charging voltage high. Check regulator.
C.
Yellow LED lights = Charging voltage low. Check connections,
wiring and alternator.
E
ngl
is
h
Содержание NBT 200
Страница 36: ...RU V1 P36 1 2 3 4 10 5 6 7 1 2 3 4 5 Russian...
