For Sales and Support, Contact Walker EMD • Toll-free: (800) 876-4444 • Tel: (203) 426-7700 • Fax: (203) 426-7800 • www.walkeremd.com
Product and Safety Notice
Use of Axiom Servo Drives
Axiom Plus systems are intended to be part of a controlled system or to operate in a stand-alone
configuration. Installation and operating instructions for all system components must be observed.
Unless otherwise specified, Axiom Plus systems are intended for use in a normal industrial environment.
Installation is to be in a suitable electrical cabinet capable of protecting the unit from exposure to excessive
moisture, corrosive agents or excessive ambient temperatures. Installation of the hardware must only be
attempted by skilled personnel and with adherence to the installation instructions in this manual. This unit
does not contain any user serviceable components. Should repair or replacement of a unit become
necessary, please contact the place of purchase for instructions.
Safety Notes
As with any electrical equipment, there are some possible hazards associated with the installation and use of
this hardware. Please observe the following precautions. Further specific Warnings and Cautions are listed
throughout this manual.
Installation and Maintenance: All installation and maintenance must be carried out by qualified personnel.
Generation: A mechanically driven motor will act as a generator. Because dangerous voltage levels may be
generated, motor to drive connections must be suitably guarded to protect against electrical shock hazards.
Cables: Use only Tol-O-Matic supplied cables, or cables deemed suitable for use by a competent person
familiar with the electrical and mechanical requirements of a given application.
Supply: Axiom Plus units must be connected to a permanent power source and fused according to the
instructions in this manual, in accordance with all local and national electrical codes.
Safety Requirements: The safe and proper installation and operation of this unit into a machine system is
the responsibility of the machine designer and should comply with all applicable local and national safety
requirements. In Europe, this is likely to include the Machinery Directive, the ElectroMagnetic Compatibility
Directive and the Low Voltage Directive. In the United States this will likely include the National Electrical
Code.
Mechanical Installation: Units must be installed inside an appropriate electrical cabinet providing
environmental controls and protection. The minimum requirements are outlined in this manual.
TOL-O-MATIC, INC.
3800 County Road 116, Hamel, MN 55340
http://www.Tolomatic.com • Email: [email protected]
Phone: (763) 478-8000 • Fax: (763) 478-8080 • Toll Free: 1-800-328-2174
Information furnished is believed to
be accurate and reliable. However,
Tol-O-Matic assumes no respons-
ibility for its use or for any errors
that may appear in this document.
Tol-O-Matic reserves the right to
change the design or operation of the
equipment described herein and any
associated motion products without
notice. Information in this document
is subject to change without notice.
