3
5. Take the 2x4 piece and insert an end into the hole in
the upper rear of the castle.
Again, the narrow side
should be parallel to the floor. Insert another wedge in-
to the end of that cross piece.
3. The end of the cross piece has a slot; put one of the wedges
through the hole in that slot. Note that the wedge has one flat
side and one angular one; the flat side should be next to the
loom. Later this wedge will be hammered into place, for now it
can just sit there.
4. Next take the 2 x 6 without the holes and place it into the
hole at the bottom near the front of the loom. This piece
should be set in with the wide side parallel to the floor. In-
sert another wedge into the slot at the end of that piece;
the wedge should be inserted back to front, with the flat
edge against the loom.
Building the Main Frame
2. Find the 2x6 with all the little holes in in it
and insert the end into the square hole at
the bottom rear of the castle side. This cross
beam should be installed so that the narrow
side is parallel to the floor.
1. Stand up the right castle side
-
the one with the cog wheel mecha-
nism mounted on the inside. Lean
the side against the wall or, if you
have two people, one person can
hold it.
1
2
3
4
5
