Abb. 4
Abb. 2
Abb. 3
I N S T R U C T I O N M A N U A L
07
I N S T R U C T I O N M A N U A L
06
Before your first use:
1. 1. Remove any packaging and factory labeling from TOB
i
™
.
2. Assemble TOB
i
™
according to the assembly instruction section, then fill the
Water Tank with water at the max level, then operate TOB
i
™
according to the
operation instructions.
Assembly Instructions
I.
Assembling and mounting the Telescopic Pole. (SEE FIG.1)
1. Loosen the ridged knob of the pole by turning it counterclockwise. Insert the
Telescopic Pole (#2A ) into the Pole (#2). Tighten the ridged knob by turning
it clockwise.
2. Loosen the ridged knob of the Telescopic Pole (#2A) part by turning it counter
clockwise. Insert the Pole Extension (#2B) into the Telescopic Pole (#2A) part.
Tighten the ridged knob by turning it clockwise.
3. Screw the Pole Extension (#2B) onto the Telescopic Pole (#2A) by turning the
Pole Extension (#2B) clockwise.
4. Place the Pole Top (#1) on top of the Pole Extension (#2B) and turn it clock
wise until lock.
NOTE: The Telescopic Pole must be fully extended during operation of the TOB
i
™
to ensure a free flow of steam through the Hose.
Fig. 1
5. Loosen the Pole Base (#3) by turning it counterclockwise.
6. Insert the bottom of the Pole into the Pole Base (SEE FIG. 2) in such a way so
that the Clothes Hanger Hook faces the rear of the TOB
i
™
. Pointing the Clothes
Hanger Hook towards the rear will ensure the stability of TOB
i
™
when garments
are hanging from the Clothes Hanger Hook.
7. Push the Pole down as far as possible.
8. Tighten the Pole Base by turning the ridged knob clockwise.
Fig. 2
Fig. 3
II.
Attaching the hose
1. Screw the Hose onto the threaded
Hose Base by turning the fitting on
the end of the Hose clockwise (SEE FIG.3).
2. Hand-tighten only. Do not over-tighten.
3. Hang the steam Nozzle on the Steam Nozzle Holder.
CAUTION:
To prevent steam from causing bodily injury or damage to surface,
always hang the Steam Nozzle on the Steam Nozzle Holder when not in use. Do
not lay the Hose on the floor as condensation may occur, causing unwanted
water droplets in the steam.
CAUTION:
Pulling on the Hose with excessive force will damage the Hose, result-
ing in a steam leak.
III.
Attachments (Upholstery & Pet/lint hair attachment)
1. Turn TOB
i
™
off, and wait until steam no longer emits from
the Steam Nozzle.
CAUTION:
To avoid burns, do not try to install the
attachments while steam is coming from the Steam Nozzle.
2. Align the pegs along the back of the attachments with
the holes on the Steam Nozzle.
3. Push as shown in FIGURE 4 until the attachments is firmly in place.
Fig. 4
