REFA FAMILY USER MANUAL
Page
17
of
27
Transfer data to PC
4.3
An USB (via optical fiber) IT-network connection is supported by the product. The
purpose of the IT-network connection is for device control and/or data transfer. The
intended information flow is:
Control from a PC to the device
Raw data from the device to the PC
The supported version of the IT network connections is:
USB: 2.0 and higher
The following section describes the installation of the USB (via optical fiber) link IT-
network connections.
Please note: No hazardous situations have been identified for the product due to
loss of the IT-network functionality.
Setup of the Refa system seen from the front and back side.
Front view
Back view
Steps to connect the system as depicted above.
1. Connect the optical fiber to the input of the Fusbi and the other end to the
fiber connector on the device. It does not make a difference which
connector goes where.
2. Connect the USB cable to the Fusbi and to a free USB port on the PC. In
case this is the first time you use the system, Windows will report that a
driver is being installed.
3. The LED next to the USB input of the Fusbi will light up green to indicate
the Fusbi is ready to use.
