32-76-00-0002
5
Rev. 6/06/18
16.
Back-up Battery:
Inside the Instrument tester a CR2032 type coin battery is used on the microcontroller
PCB to provide the necessary power to the timekeeping memory chip of the instrument during the power
off period. This to maintain the clock, calendar and setup information.
When the battery is worn out it may only be replaced by a trained service engineer!
When the battery is worn out dispose it under the ordinance of each local government or the law issued by
relating government.
The battery contains organic electrolyte.
In case of electrolyte leakage from the battery, and an eventual contact with this electrolyte to the operator
the actions described below are required.
In case of eye contact:
Flush the eyes with plenty of clean water for at least 15 minutes immediately, without rubbing. Take a
medical treatment. If appropriate procedures are not taken, this may cause an eye irritation.
In case of skin contact:
Wash the contact areas off immediately with plenty of water and soap. If appropriate procedures are not
taken, this may cause sores on the skin.
In case of inhalation:
Remove to fresh air immediately. Take a medical treatment
In case of electrolyte leakage, take it up with absorbent cloth.
This may only be done by a trained service engineer!
17.
Instrument Labels:
The following labels can be found on the instrument.
Earth (Ground)
Electrical Shock Warning
Consult the Operator’s Manual
18.
Coefficient of Friction - Peel Tester-10262018-ab5700-m44.pdf 5
Coefficient of Friction - Peel Tester-10262018-ab5700-m44.pdf 5
15-6-2020 13:40:50
15-6-2020 13:40:50
