TMG TMG-184517ST, Руководство по эксплуатации продукта

Страница: 16 / 18

Page 15 of
17
Step 11 : Stretch and tighten top cover
 The roof cover must be stretched and tied to the front and rear truss by rope
going through the flap grommets on the cover. Start from the top center and
go toward both side on each end. Add or cut the rope as needed.
 Pull and stretch the cover enough only to take wrinkles out. Repeat for the
rear truss. Do not over stretch as it could rip off the grommets (Picture 15)
(Picture 15-view from outside)
Step 12 : Tension the cover on the structure from both sides (Picture 16)
 Insert tension tubes (#14) slowly into the bottom groove pocket on both long
sides. Add the water plug (#21) on the first tension tube to avoid tearing the
fabric and add one to the end of last tube as well.
 Repeat the same step for the other side.