Wireless NVR Kit Manual
28
Explanation
Click Reset to restore the information of the wireless module to the factory setup.
4.5 PTZ setup
4.5.1 PTZ parameter setup
Operation prerequisites
：
Before the user controls the IP channel or the PTZ, please make sure that the network between the PTZ
decoder and the NVR is connected normally in advance and that the device PTZ decoder parameters are
configured.
Steps
：
1, Right click the main interface, in the shortcut menu, select the system setup, and then select the PTZ
setup in the channel setup. As shown below:
The corresponding operation is explained below
：
Operation
object
Function
Channel
Select the target channel which need to be set.
Protocol
The selection must be consistent with the PTZ protocol.
Device address Enter the address of the specified decoder.
Baud rate
Select the baud rate which matching the connected PTZ.
Copy to
In the right selecting box of the copy to button, select the target
channel, click the "copy set to" button, the system will apply the current
channel setup information to other target video channel.
