JEEP WRANGLER
Step 8: Installation of LED lamp : Tear off the double-sided adhesive tape behind the LED lamp and
stick it to the thin wall blow the apron. The distance from designated pasting position of front and rear
LED lamp to front door line of front door is shown as the picture (The distance of the front lamp is
560mm, and the rear lamp is 1650mm).
Connection of motor
wire connector
Step 9: Installation of motor wire: Connect the
t
f
t
ti
i
ith
t l
connector of motor connection wire with control
input wire and arrange the wire harness along
with the vehicle beam . At the same time, notice
that the connectors of the same color wire
h ld b
t d t
h th
C
t
should be connected to each other. Connect
motor connector with the connector of motor
connection wire. Then fasten the wire harness
on the vehicle beam by wire tie to make the
i h
t S
i i t ll ti
i f
22
Control input wire
Motor connection wire
wire harness neat. Same wire installation is for
the other side.
www.tmax.biz