C
JEEP WRANGLER
Magnetic Inductor Installation
Induction part C
B
A
C
g
B
Induction part C
B-pillar on the right
side (open the B-pillar
panel)
Earthing stud D
Wire Harness Magnetic Inductor
A
panel)
Earthing stud D
(Negative)
Insert the door signal wire
Tighten the nut connecting
B and ground terminal of
Remove the double-sided
adhesive tape at the back of
C, and stick one end on one
Brown signal wire on right side
into A.
B-pillar.
,
side of the B-pillar .
Stick the other end to
the other side of
vehicle door B-pillar.
Magnet
Magnet
Stick the magnets to the inner side of the vehicle
door and keep their positions corresponding to C.
Step 6: Open the B-pillar panel on the right side of the vehicle door,
expose the above part (as shown above), connect the brown signal
wire to female insulated terminal A, loosen the earthing stud D
(ensure there is no oil paint interface of stud and B-pillar), connect
fork type terminal B to the earthing stud and then tighten the
g
I t
ti
Th
t
iti
ft
l i
th d
i h
b
i t
fork type terminal B to the earthing stud , and then tighten the
earthing stud. Stick the induction part C to the both side of B-pillar,
stick the magnet on the inside of vehicle door which is corresponding
with induction part C. (The double-sided adhesive tape will be
thicker on magnet because of the large gap of rear vehicle door.) The
i
f hi
i
l
bl
d
bl h
i d
i
h
20
Instruction: The magnet position after closing the door is shown as above picture.
Note: Rear vehicle door use thick magnet.
connection of white signal cable and cable harness induction on the
left side are same as the installation of the right side.
www.tmax.biz
