Our Brands:
FlinQ | iProtect | Park Assist | ParkEyes | Siqura | VDG
Installations in over 80 countries
TKH Security B.V. | +31 182 592 333 | [email protected] | tkhsecurity.com
Meridiaan 32
2801 DA, Gouda
The Netherlands
PD900/PD910/PD920
January 4, 2021
Installation ManualPD900/PD910/PD920
Page 23
installing the camera. The installer may move on and allow the adhesive to seal naturally
after he or she has left.
•
It is recommended that a Teflon tape or similar plumbing pipe dope is used to seal the NPS
side of the coupling to the camera pipe adapter. Ensure that the coupling covers the Teflon
tape and is locked down tight. It is suggested that after hand tightening, a pipe wrench is
used to gain another ¼ turn or more if available.
•
After seal is punctured, it’s recommended by manufacturer to used adhesive sealant within
24 hours. As long as the characteristics or behavior of the adhesive changes, it is
recommended that unused portion be disposed of and a new tube used.
•
Bonding must occur within the first 50% of published skin time. Do not apply polyurethane
sealants and adhesive sealants on frozen nor wet surfaces. Do not apply over silicone nor in
the presence of curing silicone nor hybrid products. Avoid contact with alcohol and solvents
during curing. Sealant can be tooled immediately after applying to give desired appearance.
•
Cleanup: While sealant is still soft, cleaning can be done with the same solvents used for
surface preparation. Avoid cleaning with alcohol as it will interfere with the curing process. If
sealant is already cured, removal is done mechanically with razor knife, piano wire, sanding
or 3M™ Scotch-Brite™ Molding Adhesive and Stripe Removal Disc.
