Our Brands:
FlinQ | iProtect | Park Assist | ParkEyes | Siqura | VDG
Installations in over 80 countries
TKH Security B.V. | +31 182 592 333 | [email protected] | tkhsecurity.com
Meridiaan 32
2801 DA, Gouda
The Netherlands
PD900/PD910/PD920
January 4, 2021
Installation ManualPD900/PD910/PD920
Page 15
3
Connect cables
This section gives instructions for connecting the camera.
The models are IP66-rated to prevent water from entering the camera. However, water may still
enter the camera if the camera is not properly installed. Therefore, make sure to strictly follow the
steps below before you connect any cables.
1. Make sure that all cables and the power adapter are in a dry and water-proof environment,
for instance waterproof boxes. This is to prevent moisture accumulation inside the camera
and moisture penetration into the cables, which may lead to device breakdown.
2. While running cables, slightly bend the cables to a U-shaped curve to make a low point (as
shown below). This is to prevent water from entering the camera along the cables from
above.
3. Seal the cable entry hole of the mounting kit (see below) with thread seal tape to prevent
water from entering the camera.
4. Fasten the M4 security screw with rubber on the cap.
Caution
:
The camera shall be installed by qualified personnel only.
Installation shall be in accordance with local procedures.
