Changing Needle
Needle clamp screw
Needle clamp
Turn off the power switch.
Raise the needle to its highest position by
turning the handwheel counterclockwise,
toward you, and lowering the presser foot.
Loosen the needle clamp screw
by turning
it counterclockwise. Remove the needle from
the needle clamp
.
Insert a new needle into the needle clamp
with the flat side to the rear. When inserting
the needle into the needle clamp
, push it up
as far as it goes. Tighten the needle clamp
screw
firmly by turning it clockwise.
To see if the needle is good, place the flat
side of the needle onto something flat (needle
plate, glass, etc.).The gap between the needle
and the flat surface should be consistent. Never
use a bent or blunt needle. A damaged needle
can cause permanent snags or runs in knits,
fine silks and silk-like fabrics.
SECTION . GETTING READY TO SEW
5
Stitch Selector
(how to select stitches)
Sewing guide display
Stitch pattern in green indicator
Reset key
Choose the stitch you need and press stitch pattern button, green indicator will show
the desired stitch.
If you want to choose another stitch pattern, first press the reset key and green
indicator returns to default stitch ( stitch 1), then press your desired stitch pattern.
Stitch width and stitch length can be changed by turning sewing guide display. Each
stitch pattern can be adjusted into 5 different widths and lengths.
NOTE:
To avoid needle or fabric damage, make sure the needle is up and out of the fabric
while selecting a stitch.
Reverse Stitch Control
Press the stitch control to sew in reverse.
SECTION . GETTING READY TO SEW
14
