The position of the bobbin winder stopper is adjustable depending on the required
amount of thread on the bobbin. Using a screwdriver, loosen the screw one turn or
less ,so that you can adjust the position of the bobbin winder stopper. Do not take
the screw all the way out. Retighten the screw to fix the stopper at the desired
position.
When the bobbin is wound, turn off switch. Return the bobbin winder to its
original position by moving the spindle to left, and cut the thread as shown.
The machine will not sew until the clutch is engaged.
SECTION . GETTING READY TO SEW
8
•
Needle threader
Needle threader
Ring
Needle eye
Thread end
Raise the needle to its highest position. Paying attention to the needle point,
put ring of needle threader to go through needle eye.
Draw thread into ring and pull ring back from needle eye. Release the needle
threader and the thread has been threaded through needle eye.
NOTE:
Thread length leaves for 5-10 cm is recommended when sewing.
•
Drawing up bobbin thread
Raise the presser foot. Hold the needle thread
lightly with your left hand and rotate the
handwheel counterclockwise for one complete
turn.
Bring the bobbin thread up by pulling the needle
thread up.
Pull both threads 10 to 15 cm under and behind
the presser foot.
SECTION . GETTING READY TO SEW
11
