34
Servicing and cleaning the riveting tool
Caution
Hazard of injury if handled in an improper manner! On comple-
ting this work, there should not be any more hazard to the ope-
rator, if used as per the regulations. The operator may only
carry out the operations mentioned here. Maintenance and
service work not described in this operating manual may only
be carried out by trained specialists following instruction by
RIVETEC
on the basis of the service instructions which
also
exist. See the address on
last
page for more information on
service instructions and training.
Hazard of injury if the riveting tool falls down! The hydaulic
housing must always be kept dry, clean and oil- and fat-free.
Attention
Material damage due to corrosion! Do not use any highly active
cleaning agents or combustible liquids for cleaning purpose!
The following routine is recommended:
Grease the mandrels with a drop of non-corrosive oil at regular intervals
(see page 35 ”Maintenance Intervals”).
The riveting tool must be cleaned and checked for mechanical defects as
per the respective application type.
After the riveting tool has been cleaned and when it is to be stored for a
longer period of time, lightly grease all metal outside components with
non-corrosive grease.
H
E
Ms50_gb_241001_neu.qxd 30.10.2001 9:01 Uhr Seite 34
