16
Preparing the riveting tool
H
E
E
Note
Depending on the type of compressed air supply, it may be
necessary to connect a fitting different from the one provided, to
the riveting tool. For this, you need to have a fitting having a
1/4” Withworth-pipe-thread as per ISO 228.
Caution
Danger of injury by running riveting tool. In this event, lightly
touch the trigger to stop the riveting tool.
Attention
Material damage by compressed air!
As per norm ISO 8573-1, class 2, compressed air must be dry
and clean. We recommend that you fit a compressed air-mainte-
nance unit to the riveting tool.
• Compressed air hose should be connected to the swivel joint (11), as
prescribed.
Attention
Too narrow clearance can cause damage to material. If you do
not know the stroke setting, unscrew the adjustment screw (6.1)
for the automatic switching into the left/ handed rotation a few
turns (ca. 5 mm). This is to ensure that the piston will not hit the
back and the riveting tool will not be damaged.
Note
The operating pressure must be between a minimum of 5 and a
maximum of 7 bar!
11
6.1
Ms50_gb_241001_neu.qxd 30.10.2001 9:01 Uhr Seite 16
