Titan TTL488GDO, Инструкция по безопасности и эксплуатации

Страница: 24 / 36

NOTE: Fuel and oil deteriorate over time. It may be
difficult to start the engine if you use fuel which has
been kept for more than 30 days. Towards the end of the
season, it is advisable to put only as much fuel in the
tank as you need for each mowing of the lawn, since it
should be completely used up before storing the
product. Empty remaining fuel from the tank when
storing the product for over 30 days.
OPERATION INSTRUCTIONS
1. PRIMER
Press the primer (A4) 6 times when starting the product
with a cold engine. Do not press the primer for the warm
start. (See Fig. 9)
2. RECOIL STARTER
Pull on the recoil starter handle (A7) to start the engine.
(See Fig. 10)
WARNING! Do not suddenly release the recoil
starter handle! Always allow it to return under
controlled tension!
3. HARNESS
The harness (A8) helps the operator carry this product.
WARNING! Always attach the product to the
harness. Do not carry it just by hand!
1). To remove the harness from the loop, open the
securing clip (A9). (See Fig.11a)
2). Place the harness so that it runs over the right
shoulder, DON'T crossing the chest and back. The
securing clip must be located at the right hip. (See Fig.
11b)
3). Adjust the length of the harness (A8) so that the hook
is approximately 15 cm below your waist; locate the
product to the harness by using the securing clip
ensuring that the angle of the cutting head is
approximately 30° to the surface being cut. (See Fig.
11c)
WARNING! Always attach the product to the
harness. Do not carry it only with your hands.
4). In case of emergency, throw the product away from
the operator.
Fig. 11b
A9
A8
Fig. 11a
Fig. 11c
A8
A4
Fig. 10
A7
Fig. 9