Titan TTL488GDO, Инструкция по безопасности и эксплуатации

Страница: 27 / 36

7. GRASS TRIMMER
1). Use the trimmer head (B5) to cut smaller types of
weed, lawn grass or similar soft vegetation.
2). Remove the protection cap from the line cutter (B4).
3). Hold the product firmly so that it sits with a gap
between the product and your right side.
4). Stand upright, do not lean forward and pay attention
to posture. Keep both feet apart to help retain your
balance.
5). Hold the trimmer head just above the ground at an
angle of approximately 30°. (See Fig. 15a)
6). Move the product with slow and regular arc from left
to right before moving it back to the starting position
before trimming the next area. (See Fig. 15b)
7). Ensure the cutting head remains clean and free from
off-cuts that may cause it to jam. Check regularly. Stop
the engine, switch the ignition switch (A18) to “STOP”
and remove the spark plug connector (A2) before
checking.
8). Trim longer grass in stages, do not cut long grass in
one cut. For the best results, cut longer grass in steps.
(See Fig.15c, 15d)
9). The trimmer head is equipped with a bumper (B7)
helping to cut the trimming line (B6) while operating.
Simply tap the bumper on a firm surface and the spool
will release fresh trimming line. (See Fig. 15e)
10). A line cutter (B4) is integrated with the trimming
guard (B3) and this will cut the line to the necessary
length. (See Fig. 15f)
WARNING! The cut line will be thrown out!
Danger of injury especially for bystanders!
11). For best results, do not cut wet grass because it
tends to stick to the cutting heads and guard, prevents
proper discharge of grass trimmings, and could cause
you to slip and fall.
Fig. 15a
Fig. 15b
Fig. 15c
Fig. 15d
Fig. 15e
B4
Fig. 15f
25CC PETROL MULTI TOOL TT L488GDO