© Titan Tool. All rights reserved.
9
10
8
12
10 11
13
9
14
15
16
C
B
D
F
E
G
11
Figure 10
Figure 12
maintenance
Turn off Power Pack and unplug from power
source. Relieve pressure to the Spray gun,
lockout trigger and turn off supply pump and air
supply before cleaning or replacing filters, tips, or
any other parts failure to follw these procedures
may result in fire, explosion or injection injury.
A
7
6
Figure 9
filter replacement and cleaning
1. Disconnect material hose at fitting (1)
Figure 11. Hold material connecting
tube with the universal spanner
wrench at surface (A ).
2. Disconnect union nut (4). Do not
allow locking nut (5) to rotate while
disconnecting union nut.
3. Unscrew red filter screw (6). Figure. 9.
4. Slip filter cylinder (7) from filter screw.
5. Rinse or replace filter cylinder, (7).
6. Assemble in reverse order.
front packing adjustment
1. If there is evidence of material leakage past the front seal
(10) lightly tighten the packing nut (11) with the universal
wrench. Figure 10.
valve seal replacement
To replace valve seals you must remove the entire valve rod.
1. Actuate trigger (3) and unscrew trigger lock knob (2),
remove the compression spring. Figure 11.
2. Remove screws holding trigger asembly in place and
remove trigger (3). Figure 11.
3. Unscrew seal screw (11/C) from gun body. Figure 12.
4. Carefully remove complete valve rod by pulling end of rod
(12). Figure 12.
5. Hold the rod valve using the universal spanner at surface
(F) and using a pliers turn the valve seal (8/B) and
remove. Fig. 12.
6. Remove compression ring (9) and front seal (10). Figure
12
7. To remove push rod cap (14) hold universal spanner at
surface (E) and unscrew at surface (D). Figure 12.
8. Replace compression ring with O-Ring (9), front seal (12),
rear seal (11) and if necessary push rod seal (15) and
O-Ring (16) of the air valve. Figure 12.
9. Assemble in reverse order.
5
3
Figure 11
1
4
2
