© Titan Tool. All rights reserved.
3
Table of contents
Specifications ............................................................................. 3
Introduction ................................................................................. 3
General Description .................................................................... 4
Mounting Arrangement ............................................................... 5
Setup .......................................................................................... 6
Operation .................................................................................... 6
Cleanup ...................................................................................... 7
Tip Change ................................................................................. 8
Filter Replacement ..................................................................... 9
Front and Rear packing replacement ......................................... 9
Troubleshooting ........................................................................ 10
Parts List................................................................................... 12
Spare Tips ................................................................................ 14
Warranty ................................................................................... 16
Specifications
gm2000 Eac SPRayguN (P/N 0179673)
Air Pressure, max. .......................145 psi
Material Pressure, max. ...............3625 psi
Air Volume ...................................10 CFM@ 45 PSI
Material Volume ...........................Varies due to Tip size
Air Connector ...............................1/4 inch
Material Connector ......................NPS 1/4
Length ..........................................11.8 inches
Height ..........................................10 inches
Weight .........................................21 oz.
Input voltage ................................22 VAC
Input Current, max. ......................0.8 A
Frequency ....................................26 kHz
High Voltage ................................80 kV DC
Output Current, max. ...................100 A AC
Polarity .........................................Negative
Cable, Connecting .......................36 ft.
vm200 ElEcTROSTaTIc POWER Pack (P/N 0179637)
Length ..........................................7.5 inches
Width ...........................................4.75 inches
Height ..........................................3.5 inches
Weight .........................................3.9 lbs.
Input - VAC ..................................110 - 60 Hz
Power consumption max. ............15 W
Output Voltage .............................80 KV
Output Current max .....................0.7 A
Output Frequency ........................17 kHz
Power Cord ..................................9 ft.
NOTE: Use only coating materials with a specific
resistance of 50 - 3.5000 k Ohms. If you are not
sure of the specific resistance, check with the
coating supplier before using.
Introduction
Introduction to Electro-Static Spraying
The spraying medium is atomized using a pneumatic or
diaphragm pump and a booster air feed supply. A high DC
voltage (up to 80 kV), applied across the grounded component
and the electrode fitted to the gun body generates an electric field
and applies a negative charge to the paint particles. These repel
each other as they move from gun to workpiece and so distribute
evenly through the fine spray cloud and then uniformly deposit
on the positively grounded surface. Particles shooting past the
component remain trapped in the electric field and deposit on the
backside of the work object. Effective material yield up to 90%,
time savings up to 80%, markedly improved quality of finish, less
cleaning and a healthier environment are the principal properties
of the process.
features:
Minimum overspray
Coating by electrostatic wrap-around action
Good atomization of charged particles
advantages:
Effective material utilization up to 90%
Enormous time and labor savings
